Jumper Cables Instructions

Identify battery terminals or jump start terminals if your battery is not in the engine compartment Fig. Attach the other end of the same cable the second red jumper cable clamp to the positive terminal on the working live car battery.

How To Jump Start A Car Dummies

So before trying to revive your car you have to make sure that a dead battery is the problem.

Jumper cables instructions. And before I left I searched the Internet for instructions on how to correctly use jumper cables. How to Use Jumper Cables to Jump Start a Car. Turn off and disconnect.

Be close enough however so your jumper cables can reach easily from battery to battery. Always use the same cable to feed each leg of the crossover. Jumper cables will work only in case of a battery problem.

Connecting the Red Wire. Attach one black jumper cable clamp to the negative terminal of the working live cars battery. Leave both cars to idle at a fast pace for around 10 minutes.

Turn the ignition key in both cars to the off position. Also make sure that the ends of the cables are not touching each other. Put on eye-protection glasses.

Connect one red clamp to the positive battery post of the dead battery. Clamp one end of the red cable. Begin by parking the vehicle with the good battery next to the car with the dead battery.

With both cars off and in park connect the jumper cables in the following order. Many speakers sound better bi-wired simply because the supplied links are sonically inadequate. Always consult and take the advice of your vehicl.

Heres the part you need to pay attention to. Before Doing the Jumpstart. Please try again later.

If playback doesnt begin shortly try restarting your device. Step 3 - Prepare Your Jumper Cables. Attach one red jumper cable clamp to the positive terminal on the dead battery.

Connect the Cables. Both cars should be off. Jumper Cable Instructions.

Make sure to connect jumper cables in the proper order. One run of cable will invariably sound better than two runs at half the price. Step 4 - Open the Hood and Locate the Batteries.

Start the working vehicle and let the engine run for a few minutes. Turn off both cars engines and carefully disconnect the leads in the reverse order to the way they were connected remove the black lead from your car first and finish with the red lead from the other car. Make sure that you have turned off the vehicles ignition on both of the cars that you are using.

Connect the other red. The safest order to attach the jumper cables is as follows. You want to connect the red wires on both ends of the jumper cables.

If it wont start make sure that the cables are properly connected and have the good Samaritan run his or her engine for five minutes. The metal plates or. Straighten the jumper cables so there is no room for knots or ties in the either cable.

Try to start your vehicle. Only use the best cable that you can. Turn on the ignition key of your car to see if it produces any sound.

Also make sure the clamps do not come in contact with each other as this could cause a short circuit. If the batteries are covered by plastic hoods remove the hoods so the battery posts are exposed. FB5ZR5g1n8SjzXkE Videos you watch may be added to the TVs watch history.

Open the hoods of both cars and locate their batteries. Park your car DEAD facing or next to the car giving you the jump BOOST and open both the hood. Locate the positive and negative - posts.

How To Jump Start A Car Connect Jumper Cables Printable